Instant On - Wired

 View Only

  • 1.  Native VLAN or Port Isolation Aruba 1930

    Posted 10-20-2022 10:28 AM
    Hello,

    I had a 8 port aruba 1930 switch and I need to connect two ISP on the same switch and 2 routers (for HA Config).

    I need to isolate 3 ports (1, 2 and 3) and other 3 ports (4, 5, and 6) so they can't connect via L2 (no ARP, Broadcast, etc).

    On HP switch works ok.

    On Fortiswitch works ok.

    the idea is:

    port 1, 2 and 3 = vlan 100
    port 4, 5, and 6= vlan 200
    port 7, 8, 9 and 10 = vlan 1/ default.

    but I don't ask my ISP to change vlan on the router port, al packets in the switch with vlan 1 or default vlan, and out the switch with vlan 1 o default.
    Is inside the switch where I need to isolate the ports.

    any idea? because I try several config and can't make works, on HP and Fortiswitch works fine.

    thanks.

    ------------------------------
    Kevin Dev
    ------------------------------


  • 2.  RE: Native VLAN or Port Isolation Aruba 1930

    Posted 10-28-2022 11:49 AM
    Hey Kevin,

    This configuration should work when we have the correct membership and the PVID as shown below. Please let us know if this helps. 
    ports 1, 2, and 3 = untagged on VLAN 100, tagged on no VLAN. PVID=100.
    ports 4, 5, and 6 = untagged on VLAN 200, tagged on no VLAN. PVID=200.
    ports 7, 8, 9, and 10 = untagged on VLAN 1, tagged on no VLAN. PVID=1.


    ------------------------------
    Aruba Instant On Communications
    ------------------------------

    Original Message


Related Content