I have a very simple setup, a PFSense Netgate router where I had a Cisco catalyst with two vlans, vlan1 for office and vlan 55 for quest WIFI. This was working fine until the cisco switch died and I replaced it with the aruba 1930. I configured the new 1930 so the guest wifi AP goes into port 10 and the guest wifi network port on the netgate into to port 11.. I created vlan 55 and untagged ports 10/11 for that vlan, but I get dhcp requests from vlan1
I have been doing a ton of research and it looks like I have the correct config but I can't figure out what is going on. If i place the two connection in a seperate switch, everything is fine. What am I missing?
------------------------------
Michael Jacobacci
------------------------------